All Magnetool Battery Operated Lift Magnets are versatile, compact and fully portable. Their solid-contained power source allows them to be operated anywhere - inside or outside the plant. Chains and slings are unnecessary. operation of these magnets does not depend on an electric power source.

ADDITIONAL FEATURES

• Heavy duty ON-OFF-RELEASE SWITCH located in front and recessed for safety, yet easy to reach
• A SAFE CHARGE INDICATOR tells at a glance the charge condition of the battery.
• BUILT-IN BATTERY CHARGER plugs into any 115 Volt A.C. outlet.
• ALL UNITS are available with optional Remote Control using a heavy duty, hand held drum switch on a 6'0" cord. (must be specified at order time)
• Battery Lifts are complete with a 12 volt charger, automotive type battery and charger cable

LIFTING RECOMMENDATIONS:

These units are designed to handle high density material such as thick steel plate, blocks, smooth surfaced forgings, steel and cast iron castings, heavy, rigid, flat structural steel, burnout's, etc. They are extremely useful in lifting heavy work on and off grinders, mills, drill presses, etc. Material such as light gauge sheet metal or any material that bends or flexes excessively, small parts, shavings, turnings, scrap, etc., cannot be handled efficiently by this type of magnet.

Battery Lift Magnets are rated using a machined, flat, low carbon steel plate. The test plate used for Battery Lift 2000 and 3000 a minimum of 1-1/4" thick; on Battery Lift 5000, 11000, and 15000 the test plate is 2" thick. From this break-away test the magnets are derated by 50%. Material thinner than the test plates may be handled safely but consideration must be given to the reduced holding capacity of the magnet. As the material becomes thinner, there is less mass the magnetic force has to act on. Always snatch the load as close to the floor as possible to assure positive contact and a clean lift.